How to Make an Apple Bong in Easy Steps

If you are looking for a simple and cheap way to enjoy your herb or tobacco, you might want to try making an apple bong. An apple bong is a homemade pipe that uses an apple as the main component. Apples are easy to find, cheap to buy, and can be poked through easily to form chambers and tunnels. You can place your herb or tobacco on top of the apple and inhale the smoke through a hole inside. Apples are also biodegradable, so you don’t have to worry about disposing of them after use.

In this article, we will show you how to make an apple bong in easy steps, using common household items. You will need:

  • An apple
  • A pen or a similar object with a sharp tip
  • A knife or a spoon
  • Herb or tobacco
  • A lighter

There are two methods to make an apple bong: using a pen or using a knife and a spoon. We will explain both methods below.

Method 1: Using a Pen

This method is considered “pure” because all you need to make it is an apple and a pen. The pen will serve as the tool to poke holes in the apple and as the mouthpiece to inhale the smoke. Here are the steps:

  1. Get an apple and a pen. Make sure the apple you use is fresh and firm. A soft apple could collapse while you’re trying to bore the holes. It’s ideal to use the type of ball-point pen with a tip you can unscrew so you can take out the ink well. Otherwise, you may spill ink all over the apple. Once you take out the ink well, screw the tip back on.
  2. Remove the stem from the apple. You can use your fingers to twist or pull it off or cut a slit around the stem to remove it. Make sure you get the entire stem; if it breaks, dig into the hole with your fingers and remove it from the base.
  3. Bore a hole through the top of the apple. Place the pointed tip over the hole where the stem used to be and jam the pen into the apple at a slight angle. Push it into the apple until you’ve made a hole that extends about halfway through the apple. If the apple is difficult to push through, it may help to use a twisting motion as you push. Once you make the initial hole with the pen’s tip, you can remove the pen, unscrew the tip, and use the tip-less pen to push into the apple. The apple will slide into the hollow pen. When you’re finished making the hole, remove the pen and discard the apple piece.
  4. Bore a second hole near the bottom of the apple. It should be about half an inch from the hole at the apple’s base. Insert the pen and poke a hole that meets up with the first hole you poked.
  5. Bore a third hole on the side of the apple. Insert the pen into the apple an inch or a little more from the top hole. Push the pen into
    the apple until the third hole meets up with the chamber system you have created. This hole will serve as the carb, so it should be in a place that is convenient to cover with a finger while you’re lighting
    the pipe.
  6. Make a bowl. Use the pen or another object to carve out a hollow shape on
    the top of the apple where the first hole was drilled. This is where
    you will place your herb or tobacco.
  7. Insert
    the pen back into
    the second hole near
    the bottom of
    the apple. This will be your mouthpiece.
  8. Your
    apple bong is ready
    to use! Pack some herb or tobacco into
    the bowl, cover
    the carb with your finger, light up
    the bowl, and inhale through
    the pen.

Method 2: Using a Knife and a Spoon

This method is slightly more complicated but it allows you to hollow out
the apple and turn it into
a bong. You will need
a knife and
a spoon in addition
to
the other items. Here are
the steps:

  1. About an inch from
    the top of
    the apple, cut
    the top using
    a sharp knife. Slide
    the top off and remove
    the stem. Do not cut too close from
    the stem because you will need
    to use
    the top like
    a bowl.
  2. Use
    the spoon to scoop out
    the apple flesh from
    the inside, leaving
    a thin wall around
    the apple. Be careful not to puncture
    the wall or
    the bottom of
    the apple.
  3. Use
    the pen to poke
    a hole on
    the side of
    the apple, near
    the bottom. This will be your mouthpiece.
  4. Use
    the pen to poke another hole on
    the opposite side of
    the apple, near
    the top. This will be your carb.
  5. Place
    the top of
    the apple back on
    the apple and align it with
    the holes. You may need to use some toothpicks or skewers to secure it in place.
  6. Your apple bong is ready to use! Pack some herb or tobacco into the top of the apple, cover the carb with your finger, light up the top, and inhale through the pen.

Conclusion

Making an apple bong is a fun and easy way to enjoy your herb or tobacco. You can use either a pen or a knife and a spoon to make one, depending on your preference and availability of tools. Apples are cheap, easy to find, and biodegradable, so you don’t have to worry about wasting money or harming the environment. Plus, apples add a sweet and fruity flavor to your smoke, making it more enjoyable. Try making an apple bong today and see for yourself how simple and satisfying it is!