Here is a possible blog post about how to make an apple bong:
If you are looking for a simple and fun way to enjoy your herb or tobacco, you might want to try making an apple bong. An apple bong is a homemade pipe that uses an apple as the main component. It is easy to make, cheap, and biodegradable. Plus, it adds a fruity flavor to your smoke.
In this blog post, we will show you how to make an apple bong in two different ways: using a pen and using a knife and a spoon. Both methods are effective and require only a few minutes of your time. You will also need an apple, some herb or tobacco, and a lighter.
Method 1: Using a Pen
This method is based on the instructions from wikiHow and Cannabis Training University. Here are the steps:
- Get an apple and a pen. Make sure the apple is fresh and firm. A soft apple might collapse while you are making the holes. Also, make sure the pen has a sharp tip that can poke through the apple. You can use a ballpoint pen, a highlighter, or any other stick-like device. If the pen has ink inside, remove it first.
- Remove the stem from the apple. You can use your fingers to twist or pull it off, or cut it with a knife. Make sure you get the entire stem out.
- Bore a hole through the top of the apple. Place the pen over the hole where the stem used to be and push it into the apple at a slight angle. Stop when you reach about halfway through the apple. This hole will serve as the bowl for your herb or tobacco.
- Bore a second hole near the bottom of the apple. It should be about half an inch from the base of the apple. Insert the pen and poke a hole that meets up with the first hole you made. This hole will serve as the mouthpiece for your apple bong.
- Bore a third hole on the side of the apple. It should be about an inch or more from the top hole. Insert the pen and poke a hole that meets up with the chamber system you have created. This hole will serve as the carb, which allows you to control the airflow of your apple bong.
- Make a bowl. Use the pen or another object to carve out a hollow shape on the top of the apple where the first hole was made. Make sure it is deep enough to hold your herb or tobacco, but not too deep that it reaches the core of the apple.
Congratulations! You have just made an apple bong using a pen. To use it, pack some herb or tobacco into the bowl, cover the carb with your finger, light up your material, and inhale through the mouthpiece. When you want to clear the smoke, release your finger from the carb and inhale again.
Method 2: Using a Knife and a Spoon
This method is based on the instructions from Marijuana Seeds. Here are the steps:
<ol
